RCC Structures Design Mcqs


Q.  mutually perpendicular principal stresses acting on a soil mass, the normal stress If p1 and p2 are________________?

a. [(p – p p p to the principal plane carrying the principal stress p1, is: sin 2
b. [(p – p p p cos 2
c. [(p p p – p cos 2
d. [(p p p – p /2] sin 2


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The pitch of the main bars in a simply supported slab, should not exceed its effective depth by_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If is the sectional area of a pre-stressed rectangular beam provided with a tendon pre -stressed by a force through its centroidal longitudinal axis, the compressive stress in concrete, is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Side face reinforcement shall be provided in the beam when depth of the web in a beam exceeds_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The minimum head room over a stair must be_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If q is the punching shear resistance per unit area a, is the side of a square footing for a column of side b, carrying a weight W including the weight of the footing, the depth D. of the footing from punching shear consideration, is____________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the length of a combined footing for two columns l metres apart is L and the projection on the left side of the exterior column is x, then the projection y on the right side of the exterior column, in order to have a uniformly distributed load, is (where is the distance of centre of gravity of column loads______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the tendon is placed at an rectangular beam (sectional top edge)________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The Young’s modulus of elasticity of steel, is__________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Spacing of stirrups in a rectangular beam, is__________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Total pressure on the vertical face of a retaining wall of height h acts parallel to free surface and from the base at a distance of_____________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  For initial estimate for a beam design, the width is assumed__________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  A pre-stressed rectangular beam which carries two concentrated loads W at L/3 from either end, is provided with a bent tendon with tension P such that central one-third portion of the tendon remains parallel to the longitudinal axis, the maximum dip h is_____________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Design of a two way slab simply supported on edges and having no provision to prevent the corners from lifting, is made by_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  As per IS : 456, the reinforcement in a column should not be less than________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Bottom bars under the columns are extended into the interior of the footing slab to a distance greater than____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The advantage of reinforced concrete, is due to_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  An R.C.C. column is treated as short column if its slenderness ratio is less than_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The allowable tensile stress in mild steel stirrups, reinforced cement concrete, is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The thickness of the topping of a ribbed slab, varies between________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the length of an intermediate span of a continuous slab is 5m, the length of the end span is kept_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm