Petroleum Refinery Engineering Mcqs for Chemical

Q.  Most commonly used crude heater before the fractionation tower in a refinery is the ______________ heater?

a. Electric immersion
b. Pipestill
c. Steam coil
d. None of these


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Percentage of straight run gasoline in a typical crude oil may be around________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The main reaction in reforming is the _____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Clay treatment of petroleum products __________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Aniline point is a property of the__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following constituents present in petroleum is responsible for ash formation ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Polymerisation__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which is an anticing compound ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The reservoir rock containing petroleum has_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Ethyl mercaptan is added to the Doctor negative LPG for facilitating the detection of its leakage (by bad odour) to the extent of about ________________ ppm?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Flash point of an oil gives an idea of the___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Paraffin base crude oil as compared to asphalt base crude gives___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Phenols are added in gasoline to____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Name the hydrocarbon having the poorest oxidation stability ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A good lubricant should have high _____________________ ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The pressure (kg/cm2) and temperature (°C) maintained in electrical desalters for crude oil are respectively__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Casing head gasoline is the liquid __________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A typical yield of kerosene in straight run distillation of crude oil may be about __________________ percent?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Molecular weight of petrol may be about ____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Highest quality bitumen is produced from the __________________ crude oil?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  H/C ratio (by weight) for the same number of carbon atoms is the highest in case of____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts