Process Equipment & Plant Design Mcqs for Chemical

Q.  Minimum baffle spacing recommended in a shell and tube heat exchanger is equal to _____________________?

a. 5 cms
b. 40% of the I.D. of the shell
c. 25 cms
d. I.D. of the shell


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Cooling water fouling factors vary in the range of 0.001 to 0.003____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which tube arrangement in a heat exchanger would facilitate highest heat transfer rate ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A binary liquid Azeotropic mixture has boiling point higher than either of the components, when it shows ______________ deviation from Raoult’s Law?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  LMTD correction factor is used in heat exchanger design for____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The thickness of segmental baffles (25 -35% cut truncated plates usually) is generally _____________ the tube wall thickness?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In a multipass shell and tube heat exchanger, the baffles on shell side is primarily provided for______________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  _____________ dished head is the strongest of all?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Speed of industrial paddle agitator ranges from _____________ rpm?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In a shell and tube heat exchanger having triangular pitch, the shell side equivalent diameter is given by________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A pressure vessel is said to be made of ‘thick’ shell, if the ratio of its diameter to wall thickness is_______________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In case of a continuous distillation column, increase in reflux ratio may result in the______________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Pick out the wrong statement pertaining to the design of a long tube vertical evaporator ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The units of Young’s modulus of elasticity and ________________ are the same?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Vertical vessels are not supported by____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Baffle width is normally taken as ______________ times the tank diameter?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Rotary driers are most economically designed for the number of heat transfer units (HTU) from _________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Spherical shaped pressure vessel is considered to be the most ideal, because it can___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A cylindrical storage tank can have a self supported conical roof ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The dust collection efficiency of electrostatic precipitator increases with increase in the_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following is used to set the diameter of the distillation column ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts