Process Control & Instrumentation Mcqs for Chemical

Q.  Mass spectrometer is used for the composition analysis of____________________?

a. Alloys
b. Solids
c. Isotopes
d. None of these


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Nichol’s chart deals with __________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The deflection in diaphragm (which is used as pressure sensor in pneumatic and electronic instruments) is dependent on the metal thickness, its diameter D. and shape & number of corrugations. Its deflection is proportional to_______________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In a shell and tube heat exchanger, the flow rate of heating/cooling fluid is the ______________ variable?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Reset rate is the another term used for ____________ time?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Positioning controllers are used for _______________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Operating range of a temperature measuring instrument is 800 to 1600°C. It could be a/an _____________ pyrometer?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A bimetallic thermometer as compared to industrial mercury in glass thermometer has almost the same_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The maximum service temperature for fibre glass used as thermocouple wire insulation material is __________ °C?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Time constant is the __________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Continuous shell temperature measurement in a liquid-liquid heat exchanger is done by a __________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  What is the ratio of output amplitude to input amplitude for a sinusoidal forcing function in a first order system ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Flow rate through an orifice is _____________ the pressure differential?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following is not the triple point of water ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Measurement of sub-zero Celsius temperature in industry is done most commonly by __________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Characteristic equation is the denominator of ____________ loop transfer function?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Smoke density of the flue gas going out of the chimney is measured by a __________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The experimental response of the controlled variable y(t) for a step change of magnitude ‘P’ in the manipulated variable x(t) is shown below: The appropriate transfer function of the process is_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Mercury manometer (U-tube type) exemplifies a ______________ order system?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Liquid argon level in a pressurised storage tank (at 3 kg/cm2) is measured by a/an ____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  E.m.f. generated by thermocouples is of the order of ________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts