MCQs: The live load for a sloping roof with slope 15°, where access is not provided to roof, is taken as_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: For the buildings having a low permeability, the internal wind pressure acting normal to the wall and roof surfaces is taken as__________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: To minimize the total cost of a roof truss, the ratio of the cost of truss to the cost of purlins shall be_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The minimum thickness of plates in a steel stack should be___________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The maximum permissible span of asbestos cement sheets is______________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The maximum spacing of vertical stiffeners is_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Bearing stiffeners are provided at________________?
i) the supports
ii) the mid span
iii) the point of application of concentrated loads
The correct answer is?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The forces acting on the web splice of a plate girder are__________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Minimum spacing of vertical stiffeners is limited to________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Intermediate vertical stiffeners in a plate girder need be provided if the depth of web exceeds___________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The web crippling due to excessive bearing stress can be avoided by_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Horizontal stiffener in a plate girder is provided to safeguard against_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Economical depth of a plate girder corresponds to_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The overlap of batten plates with the main members in welded connections should be more than____________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Battening is preferable when the________________?
i) column carries axial load only
ii) space between the two main components is not very large
iii) column is eccentrically loaded
The correct answer is
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Lacing bars in a steel column should be designed to resist_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: If the 20 mm rivets are used in lacing bars, then the minimum width of lacing bar should be______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Formation of snow occurs if the cloud temperature is________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The coherence length over which there is a strong relationship between amplitudes is_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Repetitive observations of the same area at equal interval of time are useful to monitor the dynamic phenomena________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|