Design of Steel Structures Mcqs

Q.  Load factor is____________________?

a. always equal to factor of safety
b. always less than factor of safety
c. always greater than factor of safety
d. sometimes greater than factor of safety


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The maximum spacing of vertical stiffeners is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Bearing stiffeners are provided at________________? i) the supports ii) the mid span iii) the point of application of concentrated loads The correct answer is?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The forces acting on the web splice of a plate girder are__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Minimum spacing of vertical stiffeners is limited to________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Intermediate vertical stiffeners in a plate girder need be provided if the depth of web exceeds___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The web crippling due to excessive bearing stress can be avoided by_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Horizontal stiffener in a plate girder is provided to safeguard against_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Economical depth of a plate girder corresponds to_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The overlap of batten plates with the main members in welded connections should be more than____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Battening is preferable when the________________? i) column carries axial load only ii) space between the two main components is not very large iii) column is eccentrically loaded The correct answer is
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Lacing bars in a steel column should be designed to resist_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the 20 mm rivets are used in lacing bars, then the minimum width of lacing bar should be______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Formation of snow occurs if the cloud temperature is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The coherence length over which there is a strong relationship between amplitudes is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Repetitive observations of the same area at equal interval of time are useful to monitor the dynamic phenomena________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Coherence of two electromagnetic waves takes place if their phase difference is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which one of the following parameters is considered to determine the reflectance of a vegetation canopy ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  sensor IFOV is proportional to_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In case of reflection and refraction of electromagnetic radiation ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which one of the following factors does not affect the scale of the air photographs ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts