Process Control & Instrumentation Mcqs for Chemical


Q.  Liquid discharge from a tank or reservoir cannot be measured by __________________?

a. Orificemeter
b. Weirs
c. Mouthpieces
d. Notches


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Pick out the wrong statement ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  ____________ is the static characteristics of an instrument?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  High temperature of around 2000°C of incandescent gas mantles is measured by a/an __________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Zirconia probe is used for the continuous measurement of ______________ flue gases going out of the furnace?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of following error integral is considered as the best criterion in controller settings ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The amplitude ratio for the sinusoidal response of a _____________ is 1?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following is the dynamic characteristics of an instrument ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Liquid levels in autoclaves are measured by ________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  For increased speed of response of an expansion pressure spring thermometer, the thermometer bulb should have a__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following controllers has the least maximum deviation ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Out of the following thermocouple wire insulating material, the highest temperature rating is for________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Turbine flow meters are suitable for_________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Load cells are used for the measurement of __________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Gas analysis is commonly done using the___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Stalagmometer is used for the measurement of__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The transfer function for a PID controller is (where, η i is the integral (reset) time and ηD is the derivative time.) ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Polarisation of light forms the working principle of a______________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  ____________ are analysed using a Polarograph?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Dilute wine was used as a thermometric liquid initially to develop temperature scale. First empirical temperature scale developed was the _____________ scale?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The open loop transfer function of a control system is KR/(1 + TS). This represents ______________?
Category: Chemical Engineering Mcqs,   Published by: teswesm