Hydraulics & Pneumatics Test Questions

Q.  Intensifier used in pneumatic systems has output pressure

a. less than input pressure
b. more than input pressure
c. same as input pressure
d. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  In which control valve energy consumption reduces as load decreases?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is a characteristic of servo valve?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is PLC?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What causes burning of AC solenoid coil?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  When PLC connections are used instead of electrical connections, the order of operations to be performed can be interchanged by
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following reasons make water unsuitable to use as a fluid in hydraulic systems? 1. Poor lubrication 2. High viscosity 3. More leakage 4. Quickly evaporates
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The heat generated in hydraulic systems can be absorbed by
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In sliding spool valves hydraulic fluid acts as sealant to reduce leakage
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For which of the following purpose hydraulic film acts as a seal between the machined cavity and spool?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements are true? 1. Low viscosity fluids have higher leakage 2. High viscosity fluids have high pressure drop 3. Low viscosity fluids consume more power 4. Low viscosity leads to wear of components
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Pressure applied on a fluid in a container is equally distributed in all directions and acts with
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which law explains the behavior of hydraulic fluids under pressure?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Flow of oil in a pipe takes place due to
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Pressure drop in pipes, occurs due to
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  How is laminar flow characterized in a straight pipe?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Positive displacement pump used in hydraulic systems have
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Electric motor has a speed of 1200 rpm and output rate of pump is 6 cc/rev. Calculate flow rate of pump in l/min
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Calculate the power absorbed by the pump if, it has a flow rate of 20 cc/rev and develops a maximum pressure of 70 bar, when electric motor runs at a speed of 1200 rpm.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Volumetric efficiency is the ratio of
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is a hydrodynamic pump?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts