IC Engines Mcqs


Q.  Injection lag is_________________?

a. the time taken by fuel after injection (before top dead center) to reach upto auto-ignition temperature
b. time before actual fuel injection and the pump pluger starts to pump fuel
c. time corresponding to actual injection and top dead center
d. time corresponding to actual ignition and top dead center
e. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  A 4-stroke diesel engine needs about following amount of air_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  With increase in speed of vehicle, the back pressure will________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Air injection in I.C. engines refers to injection of___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The ratio of useful power; engine friction exhaust gas losses; cooling water, air and oil losses for a diesel engine is of the order of____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The system of lubrication used for motor cycles and scooters is by________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The specific fuel consumption for a petrol engine first decreases with increase in fuel air ratio and then increases with further increase in fuel air ratio. The minimum value occurs in the range of__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Diesel engines as compared to petrol engines require ______________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Auto-ignition reaction time for petrol engine first decreases with increase in fuel air ratio, reaches a minimum value and then increases with subsequent increase in fuel air ratio. The minimum value occurs in the region of________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Exhaust pipes of engines are covered with insulating marterial in order to_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The thermal efficiency of a two cycle engine as compared to four cycle engine is_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The m.e.p. of a petrol engine first increases as the fuel air ratio is increased and then decreases on further increase in fuel air ratio. The M.E.P is maximum in the zone of________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Solid injection in I.C. engines refers to injection of________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  For same power and same speed, the flywheel of a four stroke engine as compared to two-stroke I.C. engine will be________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The function of a distributor in an automobile is to__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Leakage past the piston rings and valve seats in I.C. engines with increase in speed_______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The cooling water requirement for diesel engine is of the order of________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Ignition timing of a multicylider petrol engine can be adjusted by_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  High carbon content in diesel oil used for diesel engine leads to_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The pour point of diesel oil must be_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In petrol engine, increase of cooling water temperature will_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm