Metrology & Quality Control Test Questions

Q.  Inadvertent errors are caused due to

a. improper timely feedback
b. less knowledge about the product
c. less information
d. all of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Which type of threads are used to transmit power in one direction?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which method gives accurate results when effective diameter is measured without considering the thread angle?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following instruments is used to measure base pitch of a gear in base tangent method?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following components are inspected by a Tool maker's microscope?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which dimensions can be measured using image shearing microscope?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following is used to measure velocity of an object?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are true according to Deming's Deadly Diseases?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is meant by P, D, S and A in PDSA cycle?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is capability ratio?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are true for sampling inspection?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is acceptance quality level?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which quality management program is related to the maintenance of plants and equipments?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The aim of Just-In-Time manufacturing principle is to eliminate
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Calculate the taper angle, if 8 mm and 12 mm are the diameters of A and B balls respectively. Ball A is at a height of 25 mm from the horizontal ground surface and B at 15 mm.
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What does N, P and L mean in N.P.L. Gauge interferometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is meant by hitch hiking?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Heat transfer deals with the rate of
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following has lowest thermal conductivity among the others?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In gases, the transfer of heat takes place by
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  How does the heat transfer take place in metals?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts