Turbo Machines Test Questions

Q.  In which type of turbine, the runner needs to be run full of water?

a. Impulse turbine
b. Reaction turbine
c. Both a. and b.
d. None of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Which equation is used to determine wall thickness for brittle materials?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the weld joint efficiency if pressure vessel is fabricated with single full fillet lap joint?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is not an unfired pressure vessel?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In unfired pressure vessels, category A consists of _________
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is not expressed by primary design equation?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What does Ψ mean in Lagrange's equation (LE = U + λΨ)?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is/are false if separate cylinder liner is pressed inside the cylinder of large engines?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of cylinder liners are used in engines having bore diameter more than 125 mm?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following materials are used for cylinder liners?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Thermal stress in cylinder liners can be reduced by _______
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which stress is induced in cylinder wall due to side thrust of the piston?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Assignable causes are caused due to changes in _________
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the relation between standard deviation(σ) and arithmetic mean (μ) to determine coefficient of variation (C)?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following curves have the mean value equal to zero in the graph of frequency vs random variable?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the maximum percentage loss of economic cutting speed if geometric progression ratio = 1.06 ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the geometric progression ratio if maximum and minimum spindle speeds are 500 r.p.m and 300 r.p.m respectively? (Number of speed steps = 7)
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Economic cutting speed is minimum if geometric ratio is _________
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Maximum and minimum diameter of a shaft to be machined is 100 mm and 80 mm respectively. What is the maximum spindle speed if cutting velocity is 40 m/min?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A machine tool has minimum speed of 100 r.p.m. How many speed steps are required by it to achieve speed of 200 rpm? (Geometric progression ratio = 1.06)
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which discharge method provides only intermediate discharge for low speed flat belt conveyor?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts