Applied Mechanics & Graphic Statics Mcqs

Q.  In which of the following trusses, the method of substitution is required for determining the forces in all the members of the truss by graphic statics ?

a. howe truss
b. king post truss
c. fink truss
d. warren truss


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The maximum pull in a cable, carrying a uniformly distributed load and supported at two ends which are at the same level, is at_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Minimum pull in a suspended cable with supports at two ends is equal to____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Cartesian form of the equation of catenary is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Intrinisic equation of catenary is given by____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A rope is wrapped twice around a rough pole with a coefficient of friction ‘A . It is subjected to a force Fj at one end and a gradually increasing force F2 is applied at the other end till the rope just starts slip-ping. At this instant the ratio of F2 to Fi is_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A heavy ladder resting on floor and against a vertical wall may not be in equilibrium if________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  One Newton is equivalent to________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The dimensions of power are_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The ratio of unit of force in gravitational system to that in absolute system is__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A quantity measured in the C.G.S system of units has dimensions M”2L3 T3/2. What numerical factor would be required to convert the quantity to SI units ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The dimensions of Gravitational Universal constant ‘G’ are______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  One Newton is equivalent to_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The potential energy of a particle falling through a straight shaft drilled through the earth (assumed homogenous and spherical) is proportional to____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  At the instantaneous center, the velocity of the moving lamina at any instant is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following represents the state of neutral equilibrium ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  One end of an elastic string of natural length / and modulus X is kept fixed while to the other end is attached a particle of mass m which is hanging freely under gravity. The particle is pulled down vertically through a distance x, held at rest and then released. The motion is___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A simple pendulum of length / has an energy E, when its amplitude is A. If the length of pendulum is doubled, the energy will be___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the kinetic energy and potential energy of a simple harmonic oscillator of amplitude A are both equal to half the total energy, then the displacement is equal to_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  It is observed that in a certain sinusoidal oscillation, the amplitude is linearly dependent on the frequency f. If the maximum velocity during the oscillation is V, then V must be proportional to_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A particle of mass 2 kg executes simple harmonic motion of frequency 6/71 Hz and amplitude 0.25 m. Its maximum kinetic energy is___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts