Refrigeration & Air Conditioning Mcqs

Q.  In vapour compression cycle using NH3 as refrigerant, initial charge is filled at_________________?

a. suction of compressor
b. delivery of compressor
c. high pressure side close to receiver
d. low pressure side near receiver
e. anywhere in the cycle


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  The advantage of dry compression is that________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For proper refrigeration in a cabinet, if the temperature and vapour pressure difference between cabinet and atmosphere is high, then_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  One ton of the refrigeration is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Short horizontal lines on pressure-enthalpy chart show__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Ammonia is __________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Mass flow ratio of NH3 in comparison to Freon-12 for same refrigeration load and same temperature limits is of the order of___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Where does the lowest temperature occur in a vapour compression cycle ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A certain refrigerating system has a normal operating suction pressure of 10 kg/cm gauge and condensing pressure of about 67 kg/cm. The refrigerant used is________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Highest pressure encountered in a refrigeration system should be________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If the evaporator temperature of a plant is lowered, keeping the condenser temperature constant, the h.p. of compressor required will be________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Pick up the correct statement about giving up of heat from one medium to other in ammonia absorption system ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is not a desirable property of a refrigerant_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  At lower temperatures and pressures, the latent heat of vaporisation of a refrigerant_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Formation of frost on evaporator in refrigerator ________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a refrigeration system, heat absorbed in comparison to heat rejected is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  One of the purposes of sub-cooling the liquid refrigerant is to________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Highest temperature encountered in refrigeration cycle should be________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Absorption system normally uses the following refrigerant___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a vapor compression cycle, the refrigerant immediately after expansion valve is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Choose the correct statement?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts