IC Engines Mcqs

Q.  In turbulence chamber in diesel engine__________________?

a. the shape and layout of the piston crown, the inlet port, and the valve produce the turbulent effect of fuel mixture
b. fuel is injected into an auxiliary chamber that is separated from the cylinder by an orifice or throat
c. only a part of air charge is contained in an auxiliary chamber in which the fuel starts to burn with insufficient air which due to explosion tendency
d. there are no valves
e. fuel is partly burnt by spark


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Stress concentration in static loading is_________________? Which is correct statement ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Stress concentration in cyclic loading is____________________? Which is correct statement ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If a material fails below its yield point, failure would be due to___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In Vicker’s hardness testing, the pyramid indentor apex is__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In testing a material for endurance strength, it is subjected to_______________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The notch angle of the Izod impact test specimen is________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Coaxing is the procedure of increasing__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Fatigue strength can be increased by__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Stress concentration in cyclic loading is more serious in__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The fatigue life of a part can be improved by_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Plastic flow in ductile materials_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Stress concentration is caused due to_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If a load W is applied instantaneously on a bar; then the stress induced in bar will___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Tensile strength of a mild steel specimen can be roughly predicted from following hardness test_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Rankine’s theory of failure is applicable for following type of materials___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A hot short metal is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The permissible stress for carbon steel under static loading is generally taken as__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The ultimate strength of steel in tension in comparison to shear is in the ratio of__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The fatigue limit of a material____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts