Digital Signal Processing Test Questions

Q.  In the frequency response characteristics of FIR filter, the number of bits per coefficient should be _________in order to maintain the same error.

a. Increased
b. Constant
c. Decreased
d. None of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Which block of the discrete time systems requires memory in order to store the previous input?
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type/s of discrete-time system do/does not exhibit the necessity of any feedback?
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following belongs to the category of non-recursive systems?
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Recursive Systems are basically characterized by the dependency of its output on _______
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  What does the term y(-1) indicate especially in an equation that represents the behaviour of the causal system?
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of system response to its input represents the zero value of its initial condition?
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which is/are the essential condition/s to get satisfied for a recursive system to be linear?
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following operations is/are not involved /associated with the computation process of linear convolution?
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  A LTI system is said to be initially relaxed system only if ____
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  What are the number of samples present in an impulse response called as?
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which are the only waves that correspond/ support the measurement of phase angle in the line spectra?
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Double-sided phase & amplitude spectra _____
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which kind of frequency spectrum/spectra is/are obtained from the line spectrum of a continuous signal on the basis of Polar Fourier Series Method?
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type/s of Fourier Series allow/s to represent the negative frequencies by plotting the double-sided spectrum for the analysis of periodic signals?
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  What does the signalling rate in the digital communication system imply?
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  As the signalling rate increases, _______
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which phenomenon occurs due to an increase in the channel bandwidth during the transmission of narrow pulses in order to avoid any intervention of signal distortion?
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Why are the negative & positive phase shifts introduced for positive & negative frequencies respectively in amplitude and phase spectra?
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Duality Theorem / Property of Fourier Transform states that _________
Category: Electronic Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the below assertions is precise in accordance to the effect of time scaling? A : Inverse relationship exists between the time and frequency domain representation of signal B : A signal must be necessarily limited in time as well as frequency domains
Category: Electronic Engineering Questions,   Published by: T-Code Scripts