Design of Machine Elements

Q.  In testing a material for endurance strength, it is subjected to_______________________?

a. static load
b. dynamic load
c. impact load
d. static as well as dynamic load
e. completely reversed load


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Residual stress in materials_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The ratio of endurance limit in shear to the endurance limit in flexure is__________________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Resistance to fatigue of a material is measured by________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For steel, the ultimate strength in shear as compared to ultimate strength in tension is ___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  At low temperatures (say 75°C) the notched-bar impact value of steel____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The crest diameter of a screw thread is same as _____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Maximum principal stress theory is applicable for_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A stud________________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A tap bolt_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The included angle in unified of American National threads is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Cap screws are___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The deflection of a cantilever beam under load W is 8. If its width is halved, then the deflection under load W will be________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Set screws are_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  An alien bolt is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Ball bearing type screws are found in following application_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The function of a washer is to___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For applications involving high stresses in one direction only the following type of thread would be best suited______________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Shear stress theory is applicable for____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The following type of nut is used with alien bolt____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If d is the diameter of bolt hole then for a flanged pipe joint to be leak proof, the circumferential pitch of the bolts should be_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts