Heat Transfer Questions

Q.  In regenerator type heat exchanger, heat transfer takes place by___________________?

a. direct mixing of hot and cold fluids
b. a complete separation between hot and cold fluids
c. flow of hot and cold fluids alternately over a surface
d. generation of heat again and again
e. indirect transfer


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  One horsepower is equal to_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Axial flow pump is started with its delivery valve________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Head developed by a centrifugal pump depends on___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a centrifugal pump casing, the flow of water leaving the_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Reciprocating pumps are no more to be seen in industrial applications (in comparison to centrifugal pumps) because of____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The efficiency of a centrifugal pump is maximum when its blades are__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  When a piping system is made up primarily of friction head and very little of vertical lift, then pump characteristics should be__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If a pump is handling water and is discharging a certain flow Q at a constant total dynamic head requiring a definite B.H.P., the same pump when handling a liquid of specific gravity 0.75 and viscosity nearly same as of water would discharge_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The optimum value of vane exit angle for a centrifugal pump impeller is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In centrifugal pumps, maximum efficiency is obtained when the blades are_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a centrifugal pump, the liquid enters the pump__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Low specific speed of a pump implies it is____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For small discharge at high pressure, following pump is preferred_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The horse power required in above case will be___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Motion of a liquid in a volute casing of a centrifugal pump is an example of____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Medium specific speed of a pump implies it is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Indicator diagram of a reciprocating pump is a graph between________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Any change in load is adjusted by adjusting following parameter on turbine______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The maximum number of jets generally employed in impulse turbine without jet interference is________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  High specific speed of turbine implies it is__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts