IC Engines Mcqs

Q.  In precombustion chamber in diesel engine________________?

a. The shape and layout of the pistion crown, the inlet port, and the valve produce the turbulent effect of fuel mixture
b. Fuel is injected into an auxiliary chamber that is separated from the cylinder by an orifice or throat
c. Only a part of air charge is contained in an auxiliary chamber in which the fuel starts to burn with insufficient air which due to explosion tendency
d. There are no valves


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Brittle coating technique is used for_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The endurance limit of a material with finished surface in comparison to rough surface is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The maximum stress due to stress concentration in a bar having circular transverse hole, as compared to its static stress without hole will be_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Stress concentration in static loading is more serious in__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Endurance limit or fatigue limit is the maximum stress that a member can withstand for an infinite number of load applications without failure when subjected to________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is not correct procedure to increase the fatigue limit_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Stress concentration in static loading is_________________? Which is correct statement ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Stress concentration in cyclic loading is____________________? Which is correct statement ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If a material fails below its yield point, failure would be due to___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In Vicker’s hardness testing, the pyramid indentor apex is__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In testing a material for endurance strength, it is subjected to_______________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The notch angle of the Izod impact test specimen is________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Coaxing is the procedure of increasing__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Fatigue strength can be increased by__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Stress concentration in cyclic loading is more serious in__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The fatigue life of a part can be improved by_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Plastic flow in ductile materials_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Stress concentration is caused due to_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If a load W is applied instantaneously on a bar; then the stress induced in bar will___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts