Design of Machine Elements

Q.  In order to avoid tearing of the plate at edge, the distance from the center line of the rivet hole to the nearest edge of the plate in terms of dia of rivet d should be equal to__________________?

a. d
b. 1.25 d
c. 1.5 d
d. 1.75 d
e. 2 d


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  When a close coiled helical spring is compressed, its wire is subjected to________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Belt slip may occur due to________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If two springs are in parallel then their overall stiffness will be_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Antifriction bearings are__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The usual clearance provided in hydrodynamic bearing per mm of diameter of shaft is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Oil in journal bearing should be applied at the point where load is________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In oilness bearings________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Three different weights fall from a certain height under vacuum. They will take______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In standard taper roller bearings, the angle of taper of outer raceway is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Whether any core is required in wire ropes________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Basic shaft is one__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In composite or reverse laid ropes___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  I.S. specifies following total number of grades of tolerances__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Allen bolts are___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The connecting rod bolts are tightened up so that tightening stress _________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If an application calls for stresses on screw threads in one direction only, then the following type of thread would be best suited ________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The shock absorbing capacity of a bolt can be increased by___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The connecting rod bolts are tightened up with initial tension greater than the external load so that___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  When a bolt is subjected to shock loading, the resilience of the bolt should be considered in order to prevent breakage at_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The resultant axial load on a bolt depends on_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts