|
MCQs: Maze routing is used to determine the _______path for a single wire between a set of points, if any path exists.
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: In a chip, which type/s of pad design/s is/are adopted to solve the problem of pin count?
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: The power consumption of static CMOS gates varies with the _____ of power supply voltage.
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: Which factor/s play/s a crucial role in determining the speed of CMOS logic gate?
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: In CMOS circuits, which type of power dissipation occurs due to switching of transient current and charging & discharging of load capacitance?
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: In accordance to the scaling technology, the total delay of the logic circuit depends on ______
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: In two-stage op-amp, what is the purpose of compensation circuitry?
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: According to the principle of current mirror, if gate-source potentials of two identical MOS transistors are equal, then the channel currents should be _______
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: PSSR can be defined as the product of the ratio of change in supply voltage to change in output voltage of op-amp caused by the change in power supply & _______ of op-amp.
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: Which among the following serves as an input stage to most of the op-amps due to its compatibility with IC technology?
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: Which among the following is/are responsible for the occurrence of 'Delay Faults'?
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: Due to the limitations of the testers, the functional test is usually performed at speed _______the target speed.
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: High observability indicates that ________number of cycles are required to measure the output node value.
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: Basically, an observability of an internal circuit node is a degree to which one can observe that node at the _______ of an integrated circuit.
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: The interface between an analog signal and a digital processor is
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: The speech signal is obtained after
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: Telegraph signals are examples of
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: As compared to the analog systems, the digital processing of signals allow
1) Programmable operations
2) Flexibility in the system design
3) Cheaper systems
4) More reliability
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: The Nyquist theorem for sampling
1) Relates the conditions in time domain and frequency domain
2) Helps in quantization
3) Limits the bandwidth requirement
4) Gives the spectrum of the signal
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
|
MCQs: Roll-off factor is
Category: Electronic Engineering Questions, Published by: T-Code Scripts
|
