|
MCQs: The amount of residual chlorine left in public water supply for safety against pathogenic bacteria is about______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Orthotolidine test is used for determination of________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: On standard silica scale, the turbidity in drinking water should be limited to_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Which of the following values of pH represents a stronger acid?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Standard EDTA (ethylene diamine tetra acetic aciD. solution is used to determine the_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Ground water is usually free from________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The maximum discharge of a tube-well is about_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The phenolic compounds in public water supply should not be more than_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Which of the following is not a water borne disease ?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Select the correct relationship between porosity (N), specific yield (y) and specific retention (R)________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The suitable method of forecasting popu¬lation for a young and rapidly increasing city is_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: As compared to geometrical increase method of forecasting population, arithmetical increase method gives________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: If the average daily consumption of a city is 100,000 m3, the maximum daily con¬sumption on peak hourly demand will be_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Which of the following causes a decrease in per capita consumption ?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Assertion A : The consumption of water increases with increase in the distribution pressure. Reason R : Higher distribution pressure causes more loss and waste of water. Select your answer according to the coding system given below?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The per capital consumption of a locality is affected by_________________?
1) climatic conditions
2) quality of water
3) distribution pressure
The correct answer is?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The devices which are installed for drawing water from the sources are called______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: If the coliform bacteria is present in a sample of water, then the coliform test to be conducted is_____________?
1) presumptive coliform test
2) confirmed coliform test
3) completed coliform test
The correct answer is ?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Select the correct statement__.?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Number of unknown internal forces in each member of a rigid jointed plane frame is_____________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
