Engineering Mechanics Test Questions

Q.  In detennining stresses in frames by methods of sections, the frame is divided into two parts by an imaginary section drawn in such a way as not to cut more than____________________?

a. two members with unknown forces of the frame
b. three members with unknown forces of the frame
c. four members with unknown forces of the frame
d. three members with known forces of the frame
e. four members with two known forces


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Dimensions of surface tension are___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If mercury in a barometer is replaced by water, the height of 3.75 cm of mercury will be following cm of water________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Increase in pressure at the outer edge of a drum of radius R due to rotation at corad/sec, full of liquid of density p will be___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Kinematic viscosity is dependent upon__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If w is the specific weight of liquid and k the depth of any point from the surface, then pressure intensity at that point will be________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The units of kinematic viscosity are____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Kinematic viscosity is equal to_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A one dimensional flow is one which_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A pressure of 25 m of head of water is equal to_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If 850 kg liquid occupies volume of one cubic meter, men 0.85 represents its__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A bucket of water is hanging from a spring balance. An iron piece is suspended into water without touching sides of bucket from another support. The spring balance reading will_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A liquid would wet the solid, if adhesion forces as compared to cohesion forces are________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The point in the immersed body through which the resultant pressure of the liquid may be taken to act is known as_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The conditions for the stable equilibrium of a floating body are___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The angle of contact in case of a liquid depends upon___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Rain drops are spherical because of__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The capillary rise at 20°C in a clean glass tube of 1 mm bore containing water is approximately____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If the surface of liquid is convex, men ___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  To avoid an interruption in the flow of a syphon, an air vessel is provided__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The property by virtue of which a liquid opposes relative motion between its different layers is called_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts