Mechanical Operations Mcqs for Chemical


Q.  In constant pressure filtration ?

a. Resistance decreases with time
b. Rate of filtration is constant
c. Rate of filtration increases with time
d. Rate of filtration decreases with time


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  If a force greater than that of gravity is used to separate solids & fluids of different densities, the process is termed as the __________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The ratio of the actual mesh dimension of Taylor series to that of the next smaller screen is_______________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The energy consumed by a ball mill depends on__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Size reduction of asbestos and mica is done by____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  In case of a hammer crusher, the final product size depends on the____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Tube mill compared to ball mill_______________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Tabling process used for separating two materials of different densities by passing the dilute pulp over a table/deck, which is inclined from the horizontal surface at an angle of about________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  To get ultrafine particles, the equipment used is a _________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Kick’s law assumes that the energy required for size reduction is proportional to the logarithm of the ratio between the initial and the final diameters. The unit of Kick’s constant is_________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Filtration rate through a filter cake is proportional to (where, S = filtering surface R = specific cake resistance μ = viscosity of the filtrate) ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  In continuous filtration (at a constant pressure drop), filtrate flow rate varies inversely as the__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The sphericity of a solid particle of cubical shape is ___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  To remove dirt from the flowing fluid, we use a ____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The most suitable equipment used to devulcanise rubber scrap and to make water dispersion & rubber solution is a __________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following may prove unsuitable for filtering volatile liquids ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  A screen is said to be blinded, when the___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Wet grinding in a revolving mill ______________ as compared to dry grinding ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following is not a part of the Blake jaw crusher ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Float and sink test determines the possibility of cleaning of coal by a process based on the___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Cumulative analysis for determining surface is more precise than differential analysis, because of the_______________?
Category: Chemical Engineering Mcqs,   Published by: teswesm