Optical Fiber Communication Test Questions


Q.  In circulator, an optical path of signal follows _______

a. An open loop
b. A closed loop
c. Both a and b
d. None of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  When an optical signal is incident on a photo-detector, which noise originate/s due to statistical nature of production and collection of photoelectrons?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  In an eye-diagram, digital signals with very bad interference resembles the shape of _____
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  On which factor/s do/does the response time of photodiode depend/s?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Which nature of charge carriers give rise to the current fluctuations thereby resulting into the generation of shot noise?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Which among the following parameters is/are decided by the front-end of a receiver?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  In an optical network, increase in the number of lasers ________the bit rate.
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Which band/s specify/ies the operation range of Erbium doped fiber amplifier (EDFA)?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Basically, solitons are pulses which propagates through the fiber without showing any variation in ______
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Why is an electrical isolation required between several portions of an electronic circuit?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  For measuring the shape of input pulse in time-domain intermodal dispersion method, the test fiber is replaced by another fiber whose length is less than ___ of the test fiber.
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  In chromatic dispersion, which parameter for the modulation of the received signal is measured with the help of a vector voltmeter?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Which among the following stages is/are adopted in Splice Loss Experiment?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Which among the following misalignments give/gives rise to the occurrence of splice loss?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Which function/s is/are provided by Integrated Memory Management Unit in 80386 architecture?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Which unit in 80386 DX architecture plays a crucial role in the conversion of linear address to physical address?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  In Intel x86 architecture, which general purpose register is used for repeated string instructions as well as shift, rotate and loop instructions?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Which status flag in x86 family is used to enable or disable the interrupt especially when the Pentium processor operates in the virtual mode?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Which control register in x86 family is reserved for future use and generally not adopted for current implementation?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Which functional unit of ARM family architecture is responsible for upgrading the address register contents before the core reads or writes the next register value from memory location?
Category: Electronic Engineering Questions,   Published by: teswesm
MCQs:  Which type of non-privileged processor mode is entered due to raising of high priority of an interrupt?
Category: Electronic Engineering Questions,   Published by: teswesm