Design of Steel Structures Mcqs

Q.  In case of timber structures, the simple bending formula M = fz may be applied for________________?

a. rectangular beams up to 300 mm depth
b. all rectangular beams
c. solid circular beams only
d. all square cross-section beams


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Other conditions being same, the load factor in indeterminate structures is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Load factor is____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The statical method of plastic analysis satisfies_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The moment-curvature relation at a plastic hinge is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The elastic strain for steel is about_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In case of timber structures, the form factor for solid circular cross-section is taken as_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  compression force in two end posts The pin of a rocker bearing in a bridge is designed for_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The portal bracing in a truss bridge is used to_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The centrifugal force due to curvature of track is assumed to act on the bridge at a height of___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the loaded length of span in meters of a railway steel bridge carrying a single track is 6 m, then impact factor is taken as_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The diameter of base of conical flare of a steel stack is_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The capacity of the smallest pressed steel tank is__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Steel tanks are mainly designed for_______________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Minimum pitch provided in riveted steel tanks is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  As per IS : 875, for the purposes of specifying basic wind velocity, the country has been divided into_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The external wind pressure acting on a roof depends on__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The basic wind speed is specified at a height ‘h’ above mean ground level in an open terrain. The value of’h’ is__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The live load for a sloping roof with slope 15°, where access is not provided to roof, is taken as_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For the buildings having a low permeability, the internal wind pressure acting normal to the wall and roof surfaces is taken as__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  To minimize the total cost of a roof truss, the ratio of the cost of truss to the cost of purlins shall be_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts