Design of Steel Structures Mcqs

Q.  In case of plastic design, the calculated maximum shear capacity of a beam as per IS:800 shall be________________?

a. 0.55 Awfy
b. 0.65 Awfy
c. 0.75 Awfy
d. 0.85 Awfy


ANSWER: See Answer
 
where, Aw = effective cross-sectional area resisting shear fy = yield stress of the steel
MCQs:  The portal bracing in a truss bridge is used to_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The centrifugal force due to curvature of track is assumed to act on the bridge at a height of___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the loaded length of span in meters of a railway steel bridge carrying a single track is 6 m, then impact factor is taken as_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The diameter of base of conical flare of a steel stack is_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The capacity of the smallest pressed steel tank is__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Steel tanks are mainly designed for_______________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Minimum pitch provided in riveted steel tanks is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  As per IS : 875, for the purposes of specifying basic wind velocity, the country has been divided into_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The external wind pressure acting on a roof depends on__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The basic wind speed is specified at a height ‘h’ above mean ground level in an open terrain. The value of’h’ is__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The live load for a sloping roof with slope 15°, where access is not provided to roof, is taken as_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For the buildings having a low permeability, the internal wind pressure acting normal to the wall and roof surfaces is taken as__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  To minimize the total cost of a roof truss, the ratio of the cost of truss to the cost of purlins shall be_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The minimum thickness of plates in a steel stack should be___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The maximum permissible span of asbestos cement sheets is______________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The maximum spacing of vertical stiffeners is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Bearing stiffeners are provided at________________? i) the supports ii) the mid span iii) the point of application of concentrated loads The correct answer is?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The forces acting on the web splice of a plate girder are__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Minimum spacing of vertical stiffeners is limited to________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Intermediate vertical stiffeners in a plate girder need be provided if the depth of web exceeds___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts