Design of Concrete Structures Mcqs

Q.  In case of hand mixing of concrete, the extra cement to be added is__________________?

a. 5%
b. 10%
c. 15%
d. 20%


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  In reinforced concrete footing on soil, the minimum thickness at edge should not be less than______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The slab is designed as one way if the ratio of long span to short span is_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the storey height is equal to length of RCC wall, the percentage increase in strength is_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Critical section for shear in case of flat slabs is at a distance of_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The average permissible stress in bond for plain bars in tension is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Maximum distance between expansion joints in structures as per IS : 456 – 1978 is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A higher modular ratio shows____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Ratio of permissible stress in direct compression and bending compression is______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In working stress design, permissible bond stress in the case of deformed bars is more than that in plain bars by_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Half of the main steel in a simply supported slab is bent up near the support at a distance of x from the center of slab bearing where x is equal to________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the size of panel in a flat slab is 6m x 6m, then as per Indian Standard Code, the widths of column strip and middle strip are__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The permissible diagonal tensile stress in reinforced brick work is_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  When shear stress exceeds the permissible limit in a slab, then it is reduced by____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The main reason for providing number of reinforcing bars at a support in a simply supported beam is to resist in that zone_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The limits of percentage p of the longitudinal reinforce-ment in a column is given by_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The minimum cover to the ties or spirals should not be less than________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Maximum percentage reinforcement in case of slabs is limited to___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The diameter of ties in a column should be_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The minimum diameter of longitudinal bars in a column is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For the design of retaining walls, the minimum factor of safety against overturning is taken as_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts