Building Materials & Construction Mcqs

Q.  In any good staircase, the maximum and minimum pitch respectively should be_____________?

a. 90° and 0°
b. 75° and 30°
c. 60° and 10°
d. 40° and 25°


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Normal tension is that pull which_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the length of a chain is found to be short on testing, it can be adjusted by______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Cross staff is an instrument used for________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following is not used in measuring perpendicular offsets ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For a line AB_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the true bearing of a line AB is 269° 30′, then the azimuth of the line AB is_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The length of a chain is measured from_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The maximum tolerance in a 20 m chain is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Select the incorrect statement?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For accurate work, the steel band should always be used in preference to chain because the steel band______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In the prismatic compass______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In the quadrantal bearing system, a whole circle bearing of 293° 30′ can be expressed as______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The horizontal angle between the true meridian and magnetic meridian at a place is called______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Local attraction in compass surveying may exist due to________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The prismatic compass and surveyor’s compass________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A negative declination shows that the magnetic meridian is to the________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Agate cap is fitted with a_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the magnetic bearing of the sun at a place at noon in southern hemisphere is 167°, the magnetic declination at that place is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The graduations in prismatic compass_____________? 1. are inverted 2. are upright 3. run clockwise having 0° at south 4. run clockwise having 0° at north The correct answer is ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The process of turning the telescope about the vertical axis in horizontal plane is known as______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts