Strength of Materials Test Questions


Q.  In actual machines_____________________?

a. mechanical advantage is greater than velocity ratio
b. mechanical advantage is equal to velocity ratio
c. mechanical advantage is less than velocity ratio
d. mechanical advantage is unity
e. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  If the rivets in adjacent rows are staggered and the outermost row has only one rivet, the arrangement of the rivets is called__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A riveted joint in which every rivet of a row is opposite to other rivet of the outer row, is known as______________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Efficiency of a riveted joint is the ratio of its strength (max. load it can resist without failure) to the strength of the unpunched plate in_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In riveted boiler joints, all stresses, shearing, bearing and tensile are based on the_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The ratio of elongation in a prismatic bar due to its own weight (W) as compared to another similar bar carrying an additional weight (W) will be _________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A beam is loaded as cantilever. If the load at the end is increased, the failure will occur ___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The stress induced in a body due to suddenly applied load compared to when it is applied gradually is________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A material capable of absorbing large amount of energy before fracture is known as________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The total strain energy stored in a body is termed as__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Resilience of a material is considered when it is subjected to_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  When it is indicated that a member is elastic, it means that when force is applied, it will________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The internal reaction in bottom 80 cm length will be________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The ratio of direct stress to volumetric strain in case of a body subjected to three mutually perpendicular stresses of equal intensity, is equal to___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The elasticity of various materials is controlled by its___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The stress developed in a material at breaking point in extension is called_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The stress necessary to initiate yielding is_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  If a material expands freely due to heating it will develop ____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The change in the unit volume of a material under tension with increase in its Poisson’s ratio will ________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  For which material the Poisson’s ratio is more than unity_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The property of a material which allows it to be drawn into a smaller section is called________________?
Category: Mechanical Engineering Questions,   Published by: teswesm