RCC Structures Design Mcqs


Q.  In a combined footing if shear stress does not exceed 5 kg/cm2, the nominal stirrups provided are________________?

a. 6 legged
b. 8 legged
c. 10 legged
d. 12 legged


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  To have pressure wholly compressive under the base of a retaining wall of width b, the resultant of the weight of the wall and the pressure exerted by the retained, earth should have eccentricity not more than________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Post tensioning system_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  A foundation is called shallow if its depth, is________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  A flat slab is supported_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  A pre-stressed concrete member__________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  [A + (m – 1)ASC] known as equivalent concrete area of R.C.C. is given by______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If permissible working stresses in steel and concrete are respectively 1400 kg/cm2 and 80 kg/cm2 and modular ratio is 18, in a beam reinforced in tension side and of width 30 cm and having effective depth 46 cm, the lever arms of the section, is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The maximum ratio of span to depth of a cantilever slab, is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  carrying a uniformly distributed load per metre length is suspended at the A pile of length centre and from other two points 0.15 L from either end ; the maximum hogging moment will be_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The design of a retaining wall assumes that the retained earth________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The advantage of a concrete pile over a timber pile, is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  For stairs spanning horizontally, the minimum waist provided is________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The horizontal portion of a step in a stairs case, is known as_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  A foundation rests on_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  An R.C.C. roof slab is designed as a two way slab if________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the average bending stress is 6 kg/cm2 for M 150 grade concrete, the length of embedment of a bar of diameter d according to I.S. 456 specifications, is__________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Piles are usually driven by________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  In a combined footing for two columns carrying unequal loads, the maximum hogging bending moment occurs at
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The live load to be considered for an inaccessible roof, is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than________________?
Category: Civil Engineering Mcqs,   Published by: teswesm