Soil Mechanics & Foundation Engineering Mcqs

Q.  If the sand in-situ is in its densest state, then the relative density of sand is_____________?

a. zero
b. 1
c. between 0 and 1
d. greater than 1


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Sand particles are made of________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The clay mineral with the largest swelling and shrinkage characteristics is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The total and effective stresses at a depth of 5 m below the top level of water in a swimming pool are respectively__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Quick sand is a________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Rise of water table above the ground surface causes________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Highway Research Board (HRB) classification of soils is based on__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the water table rises upto ground surface, then the___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  According to IS classification, the range of silt size particles is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Physical properties of a permeant which influence permeability are________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Effective stress on soil_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The hydraulic head that would produce a quick condition in a sand stratum of thickness 1.5 m, specific gravity 2.67 and voids ratio 0.67 is equal to_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the permeability of a soil is 0.8 mm/sec, the type of soil is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following methods is best suited for determination of permeability of coarse-grained soils ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Effective stress is______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Coefficient of permeability of soil______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following methods is more suitable for the determination of permeability of clayey soil ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Due to a rise in temperature, the viscosity and the unit weight of the percolating fluid are reduced to 60% and 90% respectively. If other things remain constant, the coefficient of permeability__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The total discharge from two wells situated near to each other is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Total number of stress components at a point within a soil mass loaded at its boundary is______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The flownet for an earthen dam with 30 m water depth consists of 25 potential drops and 5 flow channels. The coefficient of permeability of dam material is 0.03 mm/sec. The discharge per meter length of dam is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts