Design of Masonry Structures Mcqs

Q.  If the ratio of center to center spacing of intersecting walls to actual thickness of intersecting wall is more than 20, then the stiffening coefficient for wall proper will be_________________?

a. 0
b. between 0 and 1
c. 1
d. greater than 1


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Circular section of tunnels is not suitable for________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  As compared to a single free face, if a charge of explosive is placed equidistant from two faces, then the yield___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  What is the correct sequence of the following events of construction of a shaft in rock ? 1. drilling and blasting 2. timbering 3. pumping 4. mucking Select the correct answer using the codes given below Codes?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following are percussion drills ? (i) shot drill (ii) diamond drill (iii) wagon drill (iv) churn drill select correct answer?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Assertion A : English method of tunneling requires more time as compared to other methods of tunneling. Reason R : In English method of tunneling, the masons and excavators have to work alternately/
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The needle beam method of tunneling______________? (i) is suitable for soils in which roof can stand for few minutes without support (ii) is suitable for brick lining (iii) is suitable for concrete lining (iv) requires large number of trench jacks select the answer?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  American method of tunneling________________? i) is suitable for large sized tunnels ii) is no,’ suitable for railway or highway tunnel’s iii) requires heavy timbers select the correct answer?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Assertion A : When rock conditions are favorable, it will not be necessary to take up concrete lining concurrently with the driving operations till the full length of the tunnel has been driven through rock. Reason R : A tunnel through rock, hard or soft, does not need any concrete lining________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In the construction of Metro Railways, “Cut and Cover” method of construction is suitable in situations listed at________________? Consider the following situations 1. Soil is soft 2. Volume of existing surface traffic on the alignment is heavy 3. Track is at a deeper level 4. Water table is high
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  An open tank contains 1 m deep water with 50 cm depth of oil of specific gravity 0.8 above it. The intensity of pressure at the bottom of tank will be________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The total pressure on a plane surface inclined at an angle 9 with the horizontal is equal to_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Centre of buoyancy always_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Metacentric height for small values of angle of heel is the distance between the________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A rectangular block 2 m long, 1 m wide and 1 m deep floats in water, the depth of immersion being 0.5 m. If water weighs 10 kN/m3, then the weight of the block is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If a vessel containing liquid moves downward with a constant acceleration equal to ‘g’ then_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  An open cubical tank of 2 m side is filled with water. If the tank is rotated with an acceleration such that half of the water spills out, then the acceleration is equal to_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The horizontal component of force on a curved surface is equal to the_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The eddy viscosity for turbulent flow is______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In a two dimensional incompressible steady flow around an airfoil, the stream lines are 2 cm apart at a great distance from the airfoil, where the velocity is 30 m/sec. The velocity near the airfoil, where the stream lines are 1.5 cm apart, is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the velocity is zero over half of the cross-sectional area and is uniform over the remaining half, then the momentum correction factor is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts