# Airport Engineering Mcqs

Q.  If the monthly mean of average daily temperature for the hottest month of the year is 25° C and the monthly mean of the maximum daily temperature of the same month of the year is 46° C, the airport reference temperature is____________________?

a. 32°C
b. 35.5°C
c. 48°C
d. 25°C

ANSWER: See Answer

No explanation is available for this question!
 MCQs:  In an airport, if 4 groups of 5 gates each located well-separated are considered for traffic and the future to present traffic ratio is 3, then the total requirement of future gates will be______________? Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  Consider the following statements: Wind rose diagram is used for the purposes of_________________? 1. runway orientation 2. estimating the runway capacity 3. geometric design of holding apron select the correct answer? Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  Castor angle is defined as the angle______________? Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  Maximum gross take-off weight of an aircraft is__________________? Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  Which of the following is used for servicing and repairs of the aircraft ? Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  Which of the following is an example of failure in flexible pavements ? Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  For supersonic transport aircraft, the minimum turning radius of taxiway is________________? Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  Assertion A : Airport capacity during IFR conditions is usually less than that during VFR conditions. Reason R: During clear weather condition (VFR), the aircrafts on final approach to runway can be spaced closer during poor visibility conditions? Select your answer based on the coding system given below? Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  The size of landing area for multiengined helicopters operating under 1FR conditions is______________? Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  The slope of the obstruction clearance line from the boundary of the heliport should be________________? Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  The width and interval of transverse centre line bars along the extended centre line of runway, in approach lighting system are_________________? Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  According to ICAO, all markings on the runways are___________________? Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  Calm period is the percentage of time during which wind intensity is less than______________? Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  The cruising speed of the aircraft is 500 kmph. If there is a head wind of 50 kmph, then the air speed and ground speed of the aircraft respectively will be_________________? Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  As per ICAO, the minimum basic runway length for A and E type of airport will be________________? Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  The length of clear zone for none instrument runway of a small aircraft is________________? Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  Consider the following statements regarding iCAO recommendation for correction to basic runway length_________________? 1. The basic runway length should be increased at the rate of 7 percent per 300 m rise in elevation above the mean sea level 2. The basic runway length after having been corrected for elevation should be further increased at the rate of 1 percent for every 1°C rise in airport reference temperature above the standard atmospheric temperature at that elevation 3. The runway length after having been corrected for elevation and temperature should be further increased at the rate of 20% for every 1 percent of effective gradient Select the correct statment Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  Assertion A : The ratio of arriving and departing aircrafts influences the airport capacity: Reason R :Landing operation is generally given priority over the taking off operation_________________? Select your answer based on the coding system given below? Category: Civil Engineering Mcqs,   Published by: T-Code Scripts MCQs:  Malleability of a material can be defined as ______________________? Category: Mechanical Engineering Questions,   Published by: T-Code Scripts MCQs:  Mild steel belongs to the following category___________________? Category: Mechanical Engineering Questions,   Published by: T-Code Scripts