|
MCQs: The following sights are taken on a “turning point”________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: If the R.L. of a B.M. is 100.00 m, the back- sight is 1.215 m and the foresight is 1.870 m, the R.L. of the forward station is_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: As applied to staff readings, the corrections for curvature and refraction are respectively The above table shows a part of a level field book. The value of X should be________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Refraction correction________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The sensitivity of a bubble tube can be increased by________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: If the staff is not held vertical at a level¬ling station, the reduced level calculated from the observation would be_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Which of the following errors can be neutralised by setting the level midway between the two stations ?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The rise and fall method_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The difference between a level line and a horizontal line is that_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: With the rise of temperature, the sensitivity of a bubble tube______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The R.L, of the point A which is on the floor is 100 m and back sight reading on A is 2.455 m. If the foresight reading on the point B which is on the ceiling is 2.745 m, the R.L. of point B will be_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: If the horizontal distance between the staff point and the point of observation is d, then the error due to curvature of earth is proportional to_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The suitable contour interval for a map with scale 1 : 10000 is______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Contour interval is_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Dumpy level is most suitable when______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Sensitiveness of a level tube is designated by______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The difference of levels between two stations A and B is to be determined. For best results, the instrument station should be_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: An imaginary line lying throughout the surface of ground and preserving a constant inclination to the horizontal is known as__________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Select the correct statement_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: In direct method of contouring, the process of locating or identifying points lying on a contour is called_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
