Design of Steel Structures Mcqs

Q.  If the floor is supported at or near the bottom but top chords of a bridge are not braced, then the bridge is called________________?

a. deck type
b. through type
c. half through type
d. double deck type


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The connection of intermediate vertical stiffeners to the web, not subjected to external loads, shall be designed for a minimum shear force (kN/m) of___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Lug angles_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The minimum thickness of a steel plate, which is directly exposed to weather and is not accessible for cleaning and repainting, should be___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The shape factor of an isosceles triangle for bending about the axis parallel to the base is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In the virtual work method, the virtual quantity is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Other conditions being same, the load factor in indeterminate structures is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Load factor is____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The statical method of plastic analysis satisfies_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The moment-curvature relation at a plastic hinge is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The elastic strain for steel is about_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In case of timber structures, the form factor for solid circular cross-section is taken as_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  compression force in two end posts The pin of a rocker bearing in a bridge is designed for_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The portal bracing in a truss bridge is used to_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The centrifugal force due to curvature of track is assumed to act on the bridge at a height of___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the loaded length of span in meters of a railway steel bridge carrying a single track is 6 m, then impact factor is taken as_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The diameter of base of conical flare of a steel stack is_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The capacity of the smallest pressed steel tank is__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Steel tanks are mainly designed for_______________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Minimum pitch provided in riveted steel tanks is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  As per IS : 875, for the purposes of specifying basic wind velocity, the country has been divided into_____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts