IC Engines Mcqs


Q.  If petrol is used in a diesel engine, then______________?

a. higher knocking will occur
b. efficiency will be low
c. low power will be produced
d. black smoke will be produced
e. lot of fuel will remain unburnt


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Stress concentration in cyclic loading is____________________? Which is correct statement ?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  If a material fails below its yield point, failure would be due to___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In Vicker’s hardness testing, the pyramid indentor apex is__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In testing a material for endurance strength, it is subjected to_______________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The notch angle of the Izod impact test specimen is________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Coaxing is the procedure of increasing__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Fatigue strength can be increased by__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Stress concentration in cyclic loading is more serious in__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The fatigue life of a part can be improved by_____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Plastic flow in ductile materials_____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Stress concentration is caused due to_____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  If a load W is applied instantaneously on a bar; then the stress induced in bar will___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Tensile strength of a mild steel specimen can be roughly predicted from following hardness test_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Rankine’s theory of failure is applicable for following type of materials___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A hot short metal is_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The permissible stress for carbon steel under static loading is generally taken as__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The ultimate strength of steel in tension in comparison to shear is in the ratio of__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The fatigue limit of a material____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Yield point in fatigue loading as compared to static loading is__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm