|
MCQs: If T and R are tread and rise respectively of a stair, then_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: For stairs spanning l metres longitudinally between supports at the bottom and top of a flight carrying a load w per unit horizontal area, the maximum bending moment per metre width, is_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: In a singly reinforced beam, the effective depth is measured from its compression edge to_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Though the effective depth of a T-beam is the distance between the top compression edge to the centre of the tensile reinforcement, for heavy loads, it is taken as__________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: On piles, the drop must be at least_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: In a pre-stressed beam carrying an external load W with a bent tendon is having angle of -stressed load P. The net downward load at the centre is_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The diameter of longitudinal bars of a column should never be less than_____________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Steel beam theory is used for_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: To have pressure wholly compressive under the base of a retaining wall of width b, the resultant of the weight of the wall and the pressure exerted by the retained, earth should have eccentricity not more than________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Post tensioning system_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: A foundation is called shallow if its depth, is________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: A flat slab is supported_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: A pre-stressed concrete member__________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: [A + (m – 1)ASC] known as equivalent concrete area of R.C.C. is given by______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: If permissible working stresses in steel and concrete are respectively 1400 kg/cm2 and 80 kg/cm2 and modular ratio is 18, in a beam reinforced in tension side and of width 30 cm and having effective depth 46 cm, the lever arms of the section, is______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The maximum ratio of span to depth of a cantilever slab, is_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: carrying a uniformly distributed load per metre length is suspended at the A pile of length centre and from other two points 0.15 L from either end ; the maximum hogging moment will be_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The design of a retaining wall assumes that the retained earth________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The advantage of a concrete pile over a timber pile, is_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: For stairs spanning horizontally, the minimum waist provided is________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
