Design of Machine Elements

Q.  If an application calls for stresses on screw threads in one direction only, then the following type of thread would be best suited ________________?

a. square
b. acme
c. buttress
d. BSW
e. metric


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Castle nut is a locking device in which__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A backing ring is used inside the pipe joint when making a___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A tube has the following advantage over pipe_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For tight leakage joints, following type of thread is best suited ____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The function of cutting oil when threading a pipe is to___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Split nut is a locking device in which_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A bench vice has following type of threads____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Applications in which stresses are encountered in one direction only uses following type of threads____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If threads on a bolt are left hand, threads on nut will be_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Elastic nut is a locking device in which__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Turn buckle has____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A tapered key which fits in a keyway in the hub and is flat on the shaft, is known as___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A key capable of tilting in a recess milled out in a shaft is known as______________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Buttress threads are usually found on____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Jam nut is a locking device in which _____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If the tearing efficiency of a riveted joint is 75%, then the ratio of diameter of rivet to the pitch is equal to___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is a permanent fastening ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Rivets are generally specified by_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The designation M 33 x 2 of a bolt means___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Atomic number of an element in the periodic table represents the numbers of_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts