Engineering Mechanics Test Questions


Q.  If a suspended body is struck at the center of percussion, then the pressure on die axis passing through the point of suspension will be_________________?

a. maximum
b. minimum
c. zero
d. infinity
e. same as the force applied


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  A balloon lifting in air follows the following principle_____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Surface tension__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A liquid compressed in cylinder has a volume of 0.04 m3 at 50 kg/cm2 and a volume of 0.039 m3 at 150 kg/cm2. The bulk modulus of elasticity of liquid is___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following meters is not associated with viscosity____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Dimensions of surface tension are___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  If mercury in a barometer is replaced by water, the height of 3.75 cm of mercury will be following cm of water________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Increase in pressure at the outer edge of a drum of radius R due to rotation at corad/sec, full of liquid of density p will be___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Kinematic viscosity is dependent upon__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  If w is the specific weight of liquid and k the depth of any point from the surface, then pressure intensity at that point will be________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The units of kinematic viscosity are____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Kinematic viscosity is equal to_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A one dimensional flow is one which_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A pressure of 25 m of head of water is equal to_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  If 850 kg liquid occupies volume of one cubic meter, men 0.85 represents its__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A bucket of water is hanging from a spring balance. An iron piece is suspended into water without touching sides of bucket from another support. The spring balance reading will_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A liquid would wet the solid, if adhesion forces as compared to cohesion forces are________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The point in the immersed body through which the resultant pressure of the liquid may be taken to act is known as_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The conditions for the stable equilibrium of a floating body are___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The angle of contact in case of a liquid depends upon___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Rain drops are spherical because of__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm