RCC Structures Design Mcqs


Q.  If a rectangular pre-stressed beam of an effective span of 5 meters and carrying a total load 3840 kg/m, is designed by the load balancing method, the central dip of the parabolic tendon should be_________________?

a. 5 cm
b. 10 cm
c. 15 cm
d. 20 cm


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  If the modular ratio is , steel ratio is and overall depth of a beam is , the depth of the critical neutral axis of the beam, is___________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  In a simply supported slab, alternate bars are curtailed at________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Pick up the incorrect statement from the following_?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Pick up the correct statement from the following__?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Hot wire anemometer is used to measure_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Density of water is maximum at ___________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Property of a fluid by which its own molecules are attracted is called ________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The property of a fluid which enables it to resist tensile stress is known as________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The specific weight of water is 1000 kg/m” _______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  When the flow parameters at any given instant remain same at every point, then flow is said to be____________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The normal stress in a fluid will be constant in all directions at a point only if_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  An object having 10 kg mass weighs 9.81kg on a spring balance. The value of ‘g’ at this place is___________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The surface tension of mercury at normal temperature compared to that of water is____________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  For very great pressures, viscosity of moss gases and liquids __________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Viscosity of water in comparison to mercury is ______________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The bulk modulus of elasticity __________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The value of the coefficient of compressibility for water at ordinary pressure and temperature in kg/cm is equal to _________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Surface tension _____________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  A liquid compressed in cylinder has a volume of 0.04 m3 at 50 kg/cm2 and a volume of 0.039 m3 at 150 kg/cm2. The bulk modulus of elasticity of liquid is _________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Units of surface tension are_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm