Hydraulics & Pneumatics Test Questions


Q.  High specific speed of a pump implies it is_____________________?

a. centrifugal pump
b. mixed flow pump
c. axial flow pump
d. any one of the above
e. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  In a typical medium speed, 4-stroke cycle diesel engine ___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In diesel engine the diesel fuel injected into cylinder would burn instantly at about compressed air temperature of____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The rating of a diesel engine, with increase in airintlet temperature, will ___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A heat engine utilises the_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Fuel consumption of diesef engines is not guaranteed at one quarter load because at such low loads________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The term scavenging is generally associated with______________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The cam shaft of a four stroke I.C. engine running at 1500 rmp will run at __________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Most high speed compression engines operate on ___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A diesel engine as compared to petrol engine (both running ar rated load) is ____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In a cycle, the spark lasts roughly for ____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following is false statement. Some of the methods used to reduce diesel smoke are as follows ________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The magneto in an automobile is basically__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The operation of forcing additional air under pressure in the engine cylinder is known as________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Flash point of fuel oil is __________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  For the same power developed in I.C. engines, the cheaper system is_____________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Scavenging is usually done to increase__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The theoretically correct air fuel ratio for petrol engine is of the order of___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Air fuel ratio at which a petrol engine can not work is_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The following volume of air is required for consuming 1 liter of fuel by a four stroke engine_______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A 5 BHP engine running at full load would consume diesel of the order of_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm