Process Control & Instrumentation Mcqs for Chemical


Q.  Helium gas constant volume thermometer is suitable for the measurement of a temperature of ______________ °C?

a. < 100
b. < 0
c. > 0
d. > 800


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  In a shell and tube heat exchanger, the flow rate of heating/cooling fluid is the ______________ variable?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Reset rate is the another term used for ____________ time?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Positioning controllers are used for _______________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Operating range of a temperature measuring instrument is 800 to 1600°C. It could be a/an _____________ pyrometer?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  A bimetallic thermometer as compared to industrial mercury in glass thermometer has almost the same_________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The maximum service temperature for fibre glass used as thermocouple wire insulation material is __________ °C?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Time constant is the __________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Continuous shell temperature measurement in a liquid-liquid heat exchanger is done by a __________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  What is the ratio of output amplitude to input amplitude for a sinusoidal forcing function in a first order system ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Flow rate through an orifice is _____________ the pressure differential?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following is not the triple point of water ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Measurement of sub-zero Celsius temperature in industry is done most commonly by __________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Characteristic equation is the denominator of ____________ loop transfer function?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Smoke density of the flue gas going out of the chimney is measured by a __________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The experimental response of the controlled variable y(t) for a step change of magnitude ‘P’ in the manipulated variable x(t) is shown below: The appropriate transfer function of the process is_________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Mercury manometer (U-tube type) exemplifies a ______________ order system?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Liquid argon level in a pressurised storage tank (at 3 kg/cm2) is measured by a/an ____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  E.m.f. generated by thermocouples is of the order of ________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The frequency response of a dynamic element shows a constant magnitude ratio at all frequencies. The element exhibits a negative phase shift at all frequencies. The absolute value of the phase shift increases linearly with frequency. The element has the transfer function ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Paramagnetism method is not used for the composition determination of ______________ in gases?
Category: Chemical Engineering Mcqs,   Published by: teswesm