Steam Boilers, Engines, Nozzles & Turbines Mcqs


Q.  Heating value of fuel used is as on fired basis. If it is reported for dry or moisture free fuel, then latter should be multiplied by the following factor to correct for as fired value ___________________?

a. (1- moisture content)
b. (1 + moisture content)
c. 1 + moisture content
d. 1 – moisture content


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The condition of steam in boiler drum is always ___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Calorific value of coal is of the order of _______________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Boiler parameters are expressed by ___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Feed water conditioning in thermal power plants in done to__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The capacity of induced draft fan compared to forced draft fan in a boiler is__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Gardually increasing temperature of flue gases at inlet to chimney for given steam outputs is an indication of__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The three “Ts” for good combustion are____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The safety valve on boiler drum compared to safety valve on super heater is set at ________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The proximate analysis of fuel lists__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Green coal, in order to be burnt, must be____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Sulphur in coal results in___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The behaviour of coal in a furnace is determained by_______________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Pour point of fuel oil is the____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Gusset stays in a boiler are provided to____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Sulphur content of fuels is very important to the plant operators because it____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  An economiser in a boiler______________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Spontaneous combustion is a phenomenon in which____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Ultimate analysis of fuel is determination of percentage of____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which device is used in thermal power plants to reduce level of pollution___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The maximum discharge through a chimney occurs when the height of chimney is_____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm