Metrology & Quality Control Test Questions

Q.  Grade 1 is used in

a. high precision tasks
b. department of inspection
c. calibration of instruments
d. all of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Which of the following statements is/are true? 1. Probability of acceptance decreases if acceptance number increases, when sampling size is kept constant 2. Indifferent quality range is the range between lot tolerance percent defective and acceptable quality level 3. Operating characteristics curve is the curve plotted between probability of acceptance and indifferent quality range
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  On operating characteristics curve, consumers risk is denoted by
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  ISO 14000 quality standard is related with
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which ISO standard is used in international automobile companies to set automotive quality system standards ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is a characteristic of End standard?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following is measured using four ball method?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is true?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Internal diameter of any workpiece can be measured using
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is/are the factor(s) causing runout?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The snap gauge having go dimension corresponds to
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of deviation is observed while calculating hole dimensions?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  At which angle does a glass plate reflector set in N.P.L. interferometer?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which type of surface in a fringe pattern exhibits the movement of fringes towards the centre?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statements is true?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is ten point height method?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What effect does pitch error have on nut and bolt?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  According to Taylor's principle which type of gauge checks both size and geometric features?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which formula is used to calculate diametral pitch?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Analytical checking of gears includes checking of
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  What is the function of frame grabber?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts