|
MCQs: Gross head is the difference between __________.
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: What is runaway speed of the runner of Pelton wheel?
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: The gates of aerofoil section in between the outer and inner ring of guide wheel are called as ________.
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: Which of the following components of reaction turbine increases the head on the turbine by an amount equal to the height of runner outlet above the tail race?
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: As the reaction turbine works on the principle of impulse and reaction, it follows the law of ________.
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: In which type of turbine, the runner needs to be run full of water?
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: In reaction turbine work is done_______________.
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: Which of the following sentences are correct for steam turbine? 1. Steam turbine requires large floor area 2. Steam turbine is a rotary high speed machine 3. Steam turbine has low weight to power ratio 4. Steam turbine has more initial cost and maintenance cost
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: The blade speed ratio of impulse turbine is given as ___________
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: Discharge capacity of the reciprocating pump is __________ that of the centrifugal pump.
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: Which pump is more suitable for an application where very high pressure is required to be developed at moderate discharge?
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: The process of filling the liquid into the suction pipe and pump casing upto the level of delivery valve is called as _________.
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: The volute pumps and vortex volute pumps are __________ pumps with _________ shaft.
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: Which of the following centrifugal pumps has higher specific speed than the others?
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: Angular momentum of gas in the free vortex of vaneless diffuser ___________.
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: Vaneless diffusers are suitable for ___________.
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: The diffuser blades are kept ______ the number of impeller blades .
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: The ratio of actual whirl velocity to the ideal whirl velocity in the centrifugal compressor is called as _________.
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: What is the ratio of isentropic work to Euler work in an centrifugal compressor called?
Category: Mechanical Engineering Questions, Published by: teswesm
|
|
MCQs: ___________ can be defined as the ratio of the pressure rise in rotor blades to the pressure rise in stages in an axial flow compressor.
Category: Mechanical Engineering Questions, Published by: teswesm
|
