Chemical Engineering Basics Mcqs


Q.  Friction factor for fluid flow in pipe does not depend upon the________________?

a. Pipe length
b. Pipe roughness
c. Fluid density & viscosity
d. Mass flow rate of fluid


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  If a nuclear reactor produces more fissile nuclear fuel than it consumes, then it is called a _____________ reactor?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Aluminium is extracted from____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Out of the following, the joint produced by ______________ has the lowest strength?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Copper deposits are found in India at the following location ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following is an undesirable property of slag produced during the Pyrometallurgical method of metal extraction from its ore ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Dies for wire drawing are generally made of__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Maximum consumption of limestone is in the ____________________ industry?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  ‘Ice point’ is designated on Fahrenheit temperature scale by__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following is not an explosive ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The most important consideration in value engineering is the_____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  __________________ fluid force is not considered in the Navier-Stokes equation?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Auto collimator is used to check____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  ____________________ are normally subjected to sub-zero treatment?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Steel balls are manufactured by_____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  In condensers used in thermal power plants, steam is normally used in shell side and cooling water on the tube side, because of the reason that ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Wood is a/an ______________ material ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following gives the correct sequence of flow of the flue gases through the above mentioned boiler accessories ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Induced draft fans provided in large thermal power plant boilers have __________________ blades?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  In troposphere (the weather domain), the temperature ‘t’ at height ‘h’ above the sea level in metres is given by (where, temperature at sea level is 15°C and t is in °C.) ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Work done by a/an _________________ process is determined by ∫p. dv ?
Category: Chemical Engineering Mcqs,   Published by: teswesm