MCQs: If a flywheel increases its speed from 10 rpm to 20 rpm in 10 seconds, then its angular acceleration is_____________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: A car goes round a curve of radius 100 m at 25 m/sec. The angle to the horizontal at which the road must be banked to prevent sideways friction on the car wheels is tan”1 x, where x is (Assume g = 10 m/sec2)_____________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: A body is dropped from a height of 100 m and at the same time another body is projected vertically upward with a velocity of 10 m/sec. The two particles will____________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Two balls of masses 3 kg and 6 kg are moving with velocities of 4 m/sec and 1 m/sec respectively, towards each other along the line of their centers. After impact the 3 kg ball comes to rest. This can happen only if the coefficient of restitution between the balls is____________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The maximum pull in a cable, carrying a uniformly distributed load and supported at two ends which are at the same level, is at_____________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Minimum pull in a suspended cable with supports at two ends is equal to____________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Cartesian form of the equation of catenary is_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Intrinisic equation of catenary is given by____________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: A rope is wrapped twice around a rough pole with a coefficient of friction ‘A . It is subjected to a force Fj at one end and a gradually increasing force F2 is applied at the other end till the rope just starts slipping. At this instant the ratio of F2 to Fi is_____________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: A heavy ladder resting on floor and against a vertical wall may not be in equilibrium if________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: One Newton is equivalent to________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The dimensions of power are_______________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The ratio of unit of force in gravitational system to that in absolute system is__________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: A quantity measured in the C.G.S system of units has dimensions M”2L3 T3/2. What numerical factor would be required to convert the quantity to SI units ?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The dimensions of Gravitational Universal constant ‘G’ are______________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: One Newton is equivalent to_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The potential energy of a particle falling through a straight shaft drilled through the earth (assumed homogenous and spherical) is proportional to____________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: At the instantaneous center, the velocity of the moving lamina at any instant is_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Which of the following represents the state of neutral equilibrium ?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: One end of an elastic string of natural length / and modulus X is kept fixed while to the other end is attached a particle of mass m which is hanging freely under gravity. The particle is pulled down vertically through a distance x, held at rest and then released. The motion is___________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts
