Process Equipment & Plant Design Mcqs for Chemical


Q.  For turbine agitator, the impeller diameter is about_________________?

a. 0.3 to 0.5 d
b. 0.1 to 0.2 d
c. 0.65 to 0.85 d
d. 0.95 d


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Apex angle of conical heads used in the bottom heads of chemical process equipments is usually__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Length to diameter ratio of most rotary driers is in the range of____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  For identical situation, condensing film coefficient in case of a horizontal condenser is almost ______________ the value expected in case of vertical condenser?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The difficulty of liquid distribution in packed towers is accentuated, when the ratio of tower diameter to packing diameter is_________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Cooling water fouling factors vary in the range of 0.001 to 0.003____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which tube arrangement in a heat exchanger would facilitate highest heat transfer rate ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  A binary liquid Azeotropic mixture has boiling point higher than either of the components, when it shows ______________ deviation from Raoult’s Law?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  LMTD correction factor is used in heat exchanger design for____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The thickness of segmental baffles (25 -35% cut truncated plates usually) is generally _____________ the tube wall thickness?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  In a multipass shell and tube heat exchanger, the baffles on shell side is primarily provided for______________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  _____________ dished head is the strongest of all?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Speed of industrial paddle agitator ranges from _____________ rpm?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  In a shell and tube heat exchanger having triangular pitch, the shell side equivalent diameter is given by________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  A pressure vessel is said to be made of ‘thick’ shell, if the ratio of its diameter to wall thickness is_______________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  In case of a continuous distillation column, increase in reflux ratio may result in the______________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Pick out the wrong statement pertaining to the design of a long tube vertical evaporator ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The units of Young’s modulus of elasticity and ________________ are the same?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Vertical vessels are not supported by____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Baffle width is normally taken as ______________ times the tank diameter?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Rotary driers are most economically designed for the number of heat transfer units (HTU) from _________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm