Power Electronics Mcqs


Q.  For similar carrier and modulating signals, the line current used in CSI is_____________?

a. Identical to line voltage in a VSI
b. Identical to line current in VSI
c. Identical to phase voltage in VSI
d. Identical to phase voltage in CSI


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  For commutation in three phase PAC, normally balanced three phase voltages VR, VY and VB are connected to the three legs of the converter via______________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  If all the SCR’s of 3 phase PAC is replaced by diodes, they would be triggered_____________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  The ability of an electronic system to function properly in its intended electromagnetic environment and should not be a source of pollution to that electromagnetic environment is known as____________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  The opposite of susceptibility is___________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  The output current in PWM DC – DC converters is equal to___________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  A step – down choppers can be used in___________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  In a lossless inverter, the average power absorbed in one period by the load must be__________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  The ac voltage controller can be used for ___________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  In a full bridge VSI, in order to avoid the short circuit across the DC bus and the undefined AC output voltage condition, the modulating technique should ensure that___________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  The phase angle of gate signal in TRIAC can be shifted by using_____________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  In the SPWM, the modulating signal is___________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  A TRIAC can be turned on with______________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  The transfer function of PWM is generally developed in______________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  DIAC and TRIAC both are semiconductors devices and conduct in____________________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  The Graetz bridge makes excellent use of ______________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  In constant frequency PWM, at perturbation the amplitude of the sinusoidal component is a___________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  If the firing angle becomes negative, then the rectifier begins to work as_______________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  In a 3 phase half wave rectifier, when firing angle is less than 90 degree, then the average dc output voltage becomes__________________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Transformer utilization factor is a measure of the merit of a rectifier circuit. It is the ratio of_______________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  A carrier based PWM technique in CSI is composed of____________?
Category: Electrical Engineering Questions,   Published by: teswesm