Compressors, Gas Turbines & Jet Engines Mcqs

Q.  For minimum work in multistage compression, assuming same index of compression in all stages_________________?

a. work done in first stage should be more
b. work done in subsequent stages should increase
c. work done in subsequent stages should decrease
d. work done in all stages should be equal
e. work done in any stage is no criterion for minimum work but depends on other factors


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  The ratio of the increase in pressure in rotor blades to total increase in pressure in the stage is called__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Actual compression curve is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The pressure ratio of an ideal vaned compressor with increase in mass flow rate_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Gas turbine works on_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Gas turbine works on______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Rotary compressors are suitable for ____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The work ratio of a gas turbine plant is defined as the ratio of__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The pressure ratio for an open cycle gas turbine compared to closed cycle gas turbine of same h.p. is_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The fuel consumption in gas turbines is accounted for by___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Mechanical efficiency of gas turbines as compared to I.C engines is____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The air-fuel ratio in gas turbines is of the order of ______________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Gas turbine blades are given a rake___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The thermal efficiency of a gas turbine as compared to a diesel plant is__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The ratio of specific weighf/h.p. of gas turbin and I.C engines may be typically of the order of_______________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The pressure ratio in gas turbines is of the order of__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Temperature of gases at end of compression as compared to exhaust gases in a gas turbine is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The hottest point in a gas turbine is______________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Efficiency of gas turbine is increased by________________ ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The following is true for an open cycle gas turbine having exhaust heat exchanger. Atmospheric air before entering the compressor is____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The thermal efficiency of a simple gas turbine for a given turbine inlet temperature with increase in pressure ratio_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts